Author
|
Topic: Sawdust extrusion?
|
extruder services Member Posts: 4 From:Leicester, Leicestershire, UK Registered: May 2009
|
posted May 04, 2009 11:29 AM
Does anyone have any information or knowledge they're willing to share on extrusion of sawdust for making firewood briquettes please? Optimum compression ratio, L/D ratio, taper angle, in fact anything would be useful, cheers! JohnIP: Logged |
Tom C Moderator Posts: 926 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted May 04, 2009 12:19 PM
Are you looking to make fireplace logs, or charcoal briquettes?
------------------ Best Regards, Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
extruder services Member Posts: 4 From:Leicester, Leicestershire, UK Registered: May 2009
|
posted May 04, 2009 12:31 PM
Firewood briquettes. . .IP: Logged |
extruder services Member Posts: 4 From:Leicester, Leicestershire, UK Registered: May 2009
|
posted May 04, 2009 12:31 PM
wood not charcoal, just research at the mo'IP: Logged |
Tom C Moderator Posts: 926 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted May 04, 2009 01:40 PM
Here is some starter information; http://www.wvu.edu/~exten/infores/pubs/other/wood838.pdf
------------------ Best Regards, Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
extruder services Member Posts: 4 From:Leicester, Leicestershire, UK Registered: May 2009
|
posted May 04, 2009 02:01 PM
Thanks Tom, that's one of the few bits of info I've already come across, was looking for a bit more technical info really. I would have liked to have started a new forum for this, instead of putting it into the fertilizers section, any ideas please? JohnIP: Logged |
Tom C Moderator Posts: 926 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted May 04, 2009 04:54 PM
Very few people use this process, so no specific forum is required. Very few people make equipment for this process. A lot of it is home brew. I know a little bit about this process, and I'm available as a consultant. You can contact me directly at tomcun@ptd.net ------------------ Best Regards, Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|