Author
|
Topic: polyurethane tubing
|
rwatkins Member Posts: 1 From:milford center, ohio, union Registered: Nov 2006
|
posted November 07, 2006 12:43 PM
To increase burst capablity is there a way to incorporate polyester coagulent filler into polyurethane raw material pelets that may in-turn add strength to the final (tubing) product?------------------ rod watkins IP: Logged |
Tom C Moderator Posts: 785 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted November 07, 2006 12:54 PM
You might try posting under pipe and tubing.Unless you are able to braid the material so it is self reinforcing against the PU tube, it is unlikley you would get any improvement in strength. The biggest issue, amoung many, would be the chemical incompatability between the Polyester and the PU.
------------------ Best Regards, Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|