Author
|
Topic: tip and die troubles
|
GSegura Member Posts: 1 From:Juarez, Chihuahua, Mexico Registered: Nov 2005
|
posted November 09, 2005 07:28 PM
the product that I'm manufacturing is pipe in nylon 6, 15.5 mm o.d. and wall thickness is 1.7 mm I'm having some troubles with tip and die currently I'm usin a stainless steel no 304 and the trouble is when I need to change the tip is broken leaving a piece of the tip inside of the spider. Also what is the equipment to cleaning it?. currently is used a torche. some body knows which is the proper steel grade. and the proper equipment to cleaning it? thanks.. IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|