Posts: 3
From:Riyadh, Eastern province, Saudi Arabia
Registered: Oct 2005

posted October 03, 2005 02:42 PM               

---

Sirs,
I would like to get an advice regarding the seperation of iron from a plastic component. I.e. in between the two layers of plastic(HDPE) there is a thin layer of plastic mesh/net. We have to seperate the iron and re-use the plastic(HDPE). Kindly help any one who knows the technic.

------------------

IP: Logged

Posts: 621
From:Brodheadsville, PA USA
Registered: Jun 2001

posted October 06, 2005 08:55 PM               

---

Do you mean there is a thin layer of metal mesh?

------------------
Best Regards,

Tom Cunningham

Extrusion Technical Services

www.ExtrusionTechnicalServices.com

IP: Logged

Posts: 3
From:Riyadh, Eastern province, Saudi Arabia
Registered: Oct 2005

posted October 07, 2005 04:51 PM               

---

Dear Mr.Tom Cunningham,
Thanks a lot for your response and it is greatly appreciated to spare some of your precious time.
Yes there is an iron mesh in between the two layers of PVC plastic pipe cap. Expecting your advice regards. Thanks once again for your goodselves to hear our problem.
Best regards,

Rasheed.

------------------

IP: Logged

Posts: 621
From:Brodheadsville, PA USA
Registered: Jun 2001

posted October 08, 2005 09:04 PM               

---

Try these guys for magnetic seperation techniques:
http://www.eriez.com/Products/MagneticSeparators/MagneticDrumSeparator/

------------------
Best Regards,

Tom Cunningham

Extrusion Technical Services

www.ExtrusionTechnicalServices.com

IP: Logged

Posts: 3
From:Riyadh, Eastern province, Saudi Arabia
Registered: Oct 2005

posted October 14, 2005 02:45 PM               

---

Dear Mr. Cunningham,
Thanks a lot for your kind help to made available a source for our problem and we coantacted the ereiz people. Thanks once again for your good selves.
rasheed.

------------------

IP: Logged

All times are ET (US)