Author
|
Topic: Screw design
|
akhan1 Member Posts: 1 From:UK Registered: Mar 2005
|
posted March 10, 2005 06:56 AM
Hi I am doing research into cold extrusion, I'm extruding a mixture of rubber grain with plastics using a binder, the mixture is paste like. I'm using a square pitch screw, but don't get the commpression. How should I go about getting a better design for the screw.Can you please help me. IP: Logged |
Tom C Moderator Posts: 478 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted March 10, 2005 01:07 PM
Exactly what does "I don't get the compression" mean?------------------ Best Regards, Tom Cunningham Extrusion Technical Services www.ExtrusionTechnicalServices.com IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|