Author
|
Topic: pet screw
|
peter thom Member Posts: 3 From:Berlin/Germany Registered: Aug 2003
|
posted August 12, 2003 06:15 AM
I will appreciate any helpful comments to check the following design for a screw to process PET (bottle grade) for a through put of 70 kg/hour,can this screw produce 70 kg/hour of PET with an acceptable melt condition.1-screw dia.:65 mm 2-L/D ratio :22 3-feed flight depth :2.6 mm 4-compression ratio :2.4 5-screw profile :feed 50%,transition 25%,metering 25% Looking forward to help me. Regards peter IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|